• Charge a connected device. For maximum output power refer to the "Technical specifications"
on page 43.
• Connect a storage device.
• Connect a card reader.
Ú
Note: If you want to read chart cards using a USB card reader connected to the USB port,
an MI10 USB card reader is required.
The USB devices should be standard PC compatible hardware.
Ú
Note: USB cable length should not exceed 5 m when using regular cables. Lengths over
5 m may be possible with the use of an active USB cable.
USB connector details
Unit socket (female)
The unit is equipped with standard USB type-A connector(s).
24
Wiring | NSS evo3S Installation Manual
To Next Page
Loading...
Need help?
General
