EasyManuals Logo

Simrad NSS7 EVO3 COMBO User Manual

Simrad NSS7 EVO3 COMBO
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
limit setting is only active during autosteering on straight courses, NOT during course
changes. Rudder limit does not affect Non-Follow-up steering
Off heading limit: Sets the limit for the off heading alarm. An alarm occurs when the actual
heading deviates from the set heading more than the selected limit
Track response: Defines how fast the autopilot shall respond after having registered a
cross track distance
Track approach angle: Defines the angle used when the vessel is approaching a leg. This
setting is used both when you start navigating and when you use track offset
Course change confirm angle: Defines the limits for course change to next waypoint in a
route. If the course change is more than this set limit, you are prompted to verify that the
upcoming course change is acceptable.
Sailing (NAC-2/NAC-3)
Ú
Note: Sailing parameters are only available when the boat type is set to Sail.
Wind mode: Select what wind function the autopilot will use when in wind mode
-
Auto:
If TWA is <70º: Wind mode will use AWA
If TWA is ≥70º: Wind mode will use TWA
- Apparent
- True
Tack time: Controls the rate of turn (tack time) when performing a tack in wind mode.
Tack angle: Controls the angle that the boat will tack to between 50º - 150º in AUTO mode
Manual speed: If neither boat speed or SOG data is available and or deemed reliable a
manual value for speed source can be entered and used by the autopilot to aid steering
calculations
Steering response
Ú
Note: Only available for NAC-1 autopilot computers.
Used to increase or decrease the steering sensitivity. A low response level reduces the rudder
activity and provides a more loose steering. A high response level increases the rudder activity
and provides more tight steering. Too high a response level will cause the boat to make S
movements.
Installation
Used for autopilot installation and commissioning. See the separate NSS evo3 Installation
manual.
Commissioning
Ú
Note: Only available for NAC-1 autopilot computers.
Used for commissioning the rudder or virtual rudder feedback. See the separate NSS evo3
Installation manual.
62
Autopilot | NSS evo3 Operator Manual

Table of Contents

Other manuals for Simrad NSS7 EVO3 COMBO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simrad NSS7 EVO3 COMBO and is the answer not in the manual?

Simrad NSS7 EVO3 COMBO Specifications

General IconGeneral
BrandSimrad
ModelNSS7 EVO3 COMBO
CategoryMarine Equipment
LanguageEnglish

Related product manuals