____________________________________________________________________________________________________________________________
Operating Instructions Sinarback eMotion 75 LV / 75 / 54 LV 18
h. Only use the materials included in the Sinar cleaning set. These materials were tested thoroughly by Sinar
to ensure their suitability and compatibility. The user will be responsible for damages caused by the use of
other cleaning materials.
i. Meticulously careful use of the tip of a very fine brush or the tip of a tiny sponge can be employed for
removing individual dust particles from a surface. When there is more than just a little dust, short brush
stokes must be applied from the center towards the outside. The brush should be applied to the surface
very lightly.
j. Care must be used when blowing away dust particles with compressed air from a can. Condensation may
cause the accumulation of liquid inside the can. Therefore a basic precaution before an application is to
check whether the air from the spray can is truly dry. To that end, before blowing on the surface to be
cleaned, always first spray air from an appropriate distance towards the floor in order to clear the nozzle
of any accumulated liquid. Sinar recommends "Ultra Jet Duster Refill" from Chemtronics.
k. It is very important to carefully remove any loose dust particles before wiping a surface.
l. Never use a dry cleaning cloth to wipe a dusty, uncleaned surface, because the dirt particles being rubbed
into the surface may create scratches on those surfaces. The wiping movement should be performed
without pressure and it should always be in one direction only (not back and forth).
m. A visible difference between a cleaned and an untreated area after a partial cleaning of a surface indi-
cates the presence of a large soiled area that will require an overall cleaning of the complete surface. In
such cases, the entire surface should be wiped in only one direction (not back and forth), and in uninter-
rupted, continuous strokes across the whole surface. The cleaning cloth should be folded after each wip-
ing procedure in such a way that the used portion will not be in use.
n. Wiping motions across protruding or sharp edges, which would occur when the area to be cleaned is
framed by a raised edge, must be avoided at all times. In that situation, first wipe the surface along the
edge and then wipe it just to the edge, but not across it.
o. Never let the cleaning fluid drip directly on the surface to be cleaned, always apply it to the cleaning cloth
first.
p. After the wet-cleaning with a non-volatile (slowly-drying) cleaning fluid and a clean, dry cleaning cloth,
carefully wipe the surface dry from the center to the edges (not back and forth) in order to avoid residual
drying marks.
q. If drying residues are still visible after the first cleaning procedure, the procedure should be repeated care-
fully with a fresh cleaning cloth. If repeated cleaning efforts do not yield the desired results, the cleanli-
ness of the cleaning cloths and the cleaning fluids should be examined.
To Next Page
Loading...
