Singer 281-5 - Adjusting Needle Thread Tension Releaser; To Change Feed Wheel; To Change Feed Roller

ll
iNeeaie rnreaa Tension reieoser snouia release
ension whenever presser foot is raised to its highesi
If tension is not FULLY released when presser
oot is raised or is partially released when presser
oot is down: - • - Loosen clamping screw on lifting
[uide shown in Fig. 63, and
raise guide high enough
o obtain access to tension releaser screw. Loosen
ension releaser screw and RAISE, releaser bracket ti
elease tension LATER, or LOWER releaser bracket ti
elease tension SOONER. Securely tighten tension
eleoser screw.
Make certain that feed wheel Is aligned with feed
log
OS shown in Fig.64 and that there is no bind in
ipper feed
assembly. Then, securely tighten lifting
uide clamping screw.
From the library of: Superior Sewing Machine & Supply LLC