8.
Loosen
the
nut
and
turn
the
thread
cutter
connecting rod 0 and remove it.
9. Loosen the screw
0,
and while pulling off the
scissors push lever assembly
0,
remove the thread
take-up leverarm
0.
113
Feed
1. Loosen the screw
O.
2. Remove the stud screw
O,
and remove the feed
reverse lever O and the feed connecting rod O
together. Becareful
not
to
drop
the roller on the
end
of
the
feed
reverse
lever.
3. Remove the brake wire o and the brake wire pull
spring 0 together.
4. Remove the screw O (left-hand thread) and the
washer
O,
and
then remove the feed cam
0.
[IT]
Needle
bar
1. Loosen the needle bar clamp screw
0.
2. Remove the oil cap
0,
and then loosen the screw
0 and remove the needle bar supporter guide
0.
3. Removethe oil cap
0,
and then pull out the needle
bar 0 and remove the needle bar supporter
0.
4. Slant the needle bar supporter
0,
and then pull out
the needle
bar
0
and
remove the needle
bar
supporter
0.
5.
Remove
theslideblock0 and the
needle
barclmap
0
6. Remove the oil cap
0,
and then loosen the two
screws
0 and removethe
needle
bar crank 0 with
the needle
crank
rod 0 attached to it.
7. Loosen the screws
0,
and remove the thread take-
up leverstud 0 and the
needle
thread take-up
0.
-16-
0
0
--"m
f
0
0
0-®--
To Next Page
Loading...
