[IT]
Clutch
and
brake
1. Fix the stop leverspringO on the stop leverO and
insert
this
from
the
side
of
the
arm.
Attach
the
belt
shift drive lever O to the end and temporarily
tighten the bolt O so that there is no play in the
direction
of
the
thrust.
2. Fix the emergency stop lever spring O on the
emergencystop lever
0,
and attach this to the stop
lever O with the washer 0 and screw
0.
3. Attach the clutch lever assembly 0 with the clutch
lever shaft 0 and tighten the two screws
O.
4. Insert
the
clutch
stopper
in the
stopper
cam
groove
(in the
stop
condition).
5. When the center of the hole of the ball joint 0 and
the
center
of
the
attachment
hole
of
the
clutch
lever
0 are lined up, adjust the length of the upper
thread cutter connecting rod 0 so that the space
between the upper thread cutter lever pin 0 and
upper thread cutter connecting rod support 0 is I
mm, and then after tightening the stud screw
0,
tighten the nut
0.
6. Attach the clutch spring
0,
and adjust the spring
adjustment plate 0 so that its angle is
approximately 45°, and then tighten the screw
0.
7. Attach the brake spring
0.
8. Engage the clutch
and
start
the machine. Adjust the
space between the
stopper
on
the
clutch
and
the
arm
so that it is 13 mm, and then tighten the bolt
0.
[H]
Cutter
safety
device
1. Attach the thread tension bracket 0 to the arm,
and tighten the screw
0.
2. Attach the thread take-up lever 0 to the thread
take-up lever arm 0 with the stud screw
0.
3. Attach the tension releaser 0 with the stud screw
0 and the washer 0 and screw
0.
-29-
(Q>
>
v®;
13
mm
0
0
To Next Page
Loading...
