© Jul. 2022 3-4 AB10ERJN Operation Manual
SAFETY
TIPPING HAZARD
• Do not use the platform or boom
assembly to push other machines
or objects.
• Do not allow the platform or boom
assembly touch nearby
structures.
• Do not tie off the platform with
ropes or other binding materials
to the nearby structures.
• Do not put any load outside the
platform.
• When the platform is caught or
stuck or when other objects in the
vicinity impede its normal
movement, do not use the
platform controller to lower the
platform. If you intend to lower the
platform with the ground
controller, you must operate it
only after all personnel have left
the platform.
WORK ENVIRONMENT
HAZARDS
UNSAFE JOBSITE HAZARDS
• Do not operate the machine on
surfaces, edges or potholes that
cannot bear the weight of the
machine. Raise or extend the
boom only when the machine is
on firm, flat ground.
• Never drive the machine on
uneven terrain or unstable
surfaces or in other dangerous
conditions when the platform is
raised.
• When the machine is on rough
ground with gravel or other
uneven surfaces, or near holes
and steep slopes, maintain a
minimum distance of 0.6m (2ft)
and reduce the speed.
• Do not use the tilt alarm as a level
indicator. The tilt alarm on the
platform will sound only when the
machine is heavily tilted.
• If the tilt alarm sounds when the
machine travels up a slope, lower
the boom as per the following
procedures and move the
machine onto firm level ground.
Make sure not to rotate the boom
while lowering the boom.
1. Lower the main boom;
2. Lower the articulating boom;
3. Retract the telescoping boom.
• If the tilt alarm sounds when the
machine travels down a slope,
lower the boom as per the
following procedures and move
the machine onto firm level
ground. Make sure not to rotate
the boom while lowering the
boom.
1. Retract the telescoping boom;
2. Lower the articulating boom;
3. Lower the main boom.
• The drive speed should not
exceed 1.1 km/h (0.68 mph) when
the platform is raised.
To Next Page
Loading...
