Sinoboom AB10ERJN - After Using the Machine

© Jul. 2022 3-12 AB10ERJN Operation Manual
SAFETY
WELDING HAZARDS
• Comply with the welder
manufacturer’s recommendations
for procedures concerning proper
use of the welder.
• Welding leads or cables may only
be connected after turning off the
power unit.
• Carry out welding operations only
after the welding cable has been
correctly connected.
• Do not use the machine as a
ground wire during welding
operation.
• At all times, make sure that the
power tools are completely stored
in the working platform. Do not
hang the power tools on the
railing of the working platform or
the work area outside the working
platform, or hang the power tools
directly by the wire.
Before performing welding, grinding and polishing work,
welders must seek permission of the responsible
department at the workplace.
AFTER USING THE
MACHINE
1. Choose a safe parking location on sturdy, level
ground, free of obstructions and without heavy
traffic.
2. Lower the boom to stowed position.
3. Remove all loads from the platform.
4. Push in the emergency stop button at the platform
controller to the OFF position.
5. Close the cover of platform controller to protect the
control panel, handles and controller from hostile
weather conditions.
6. Push in the emergency stop button at ground
controller to the OFF position.
7. Turn the key switch at the ground controller to OFF
position and remove the key to avoid unauthorized
operation of the machine.
8. Turn off the main power switch.
NOTICE
After using the machine, the main power switch must
be disconnected.