SAFETY
AB10ERJN Operation Manual 3-11 © Jul. 2022
LITHIUM BATTERY HAZARD
• Only use the dedicated charger to
charge the battery.
• Do not allow lens, needles or
other sharp objects to contact
with the battery, otherwise the
battery membrane will easily get
damaged.
• Do not immerse the battery into
the sea or water for an extended
period of time.
• Do not use the machine with the
battery close to a heat source (-
fire, heater, etc).
• Do not use the battery with the
positive or negative terminals
installed inversely.
• Do not directly connect the
battery to a power outlet .
• Do not throw the battery into a fire
or heater,
NOTICE
After charging the battery, ensure that:
• The battery cable connections are free of
corrosion.
• The battery hold-down and cable connections are
secured.
Adding terminal protection and anti-corrosion
sealants will help reduce corrosion of the battery
terminals and cables.
HYDRAULIC HAZARDS
BURN AND SPRAY HAZARDS
• When the hydraulic system is hot,
do not touch to avoid severe skin
burn.
• After the machine shutdown,
thoroughly clean the spilled
hydraulic oil. Do not throw the oil
on the ground. Once the
maintenance and repair is
complete, immediately clean any
oil on the skin, Dispose of the
used oil as per the governing laws
and regulations.
• Do not use your hand to block the
hydraulic leaks. If the leakage
occurs, please first release the
system pressure and maintain
only after the hydraulic oil cools
down. If any injury is caused by
the spray of hydraulic oil, go to
the doctor immediately, otherwise
severe complication may develop.
WELDING AND POLISHING
REQUIREMENTS
Before welding, grinding and polishing operations,
always ensure you read and understand all operation
and maintenance requirements in the Operation
Manual and the Maintenance Manual.
To Next Page
Loading...
