Siruba PK511 User Manual

SiMUaA ®
Sew Reach
P06
Introduction
( 2-2. Lubrication )
WARNING :
To p,otect against ponlble per90nal Injury due to abrupt start of the machine, be aure to start the
following wot1t after turning the power off end Hcertalnlng thllt the motor la et ,..._
/-----------
1
:(ij 6?
( 2-3. Attaching the needle)
WARNING :
1) Open the side cover , and apply N ew Defrix Oil No. 1 to the
portions shown by the red marks e to • <• : PK511 J-NS ).
(Apply approximately 1 cc of oil to the respective lubricating
places one to two times a week .)
2) Loosen connecting screw • • tilt the machine head backward
and apply grease ( designated grease) to crossed helical gea r
• and worm gear•·
3) Check, approximately once a week, that oil amount is sufficient
to reach the top of the oil felt placed inside the bed mounting
base . II the amount of oil is insufficient, add an adequate amount
of oil. At this time , also apply oil to crank rod e.
---- --------------~
(Caution et the time of lubricating]
1. Take care not to allow apeed alowlng friction
wheel • end friction plate • to be clogged with
oil to pre vent them from the deterioration of
retardation performance. In addition , when the
componenta are clogged with oll , wipe the oil
from them.
2. Take care not to a llow the machine belt to
be clogged with oil to prevent It from the
deterioration.
To protect against poaelble pereonel Injury due to abrupt start of the machine, be aure to start the
following wort( aft« tumlng the power off and ucertalnlng that the motor la It rest.
* Use a standard needle of TQx1 #16 .
Loosen setscrew • and hold needle • with the long
groove facing toward you. Then fully insert it into the
hole in the needle bar , and tighten setscrew • ·
From the library of Superior Sewing Machine & Supply LLC • www.supsew.com

Siruba PK511 Specifications

General

Brand	Siruba
Model	PK511
Category	Sewing Machine
Language	English