Wireless Range Extender (WL-130) Configuration
14
address to act as a station to connect to another peer or access
point. You also can click “Clone MAC” button to let this device
copy the MAC address of the PC you are using to configure this
device.
Root AP SSID
In “Universal Repeater mode”, this device can act as a station
to connect to a Root AP. You should assign the SSID of the Root
AP here.
Set Security
In “AP Bridge-WDS mode”, you can click “Set Security” to add
encryption for the communication between the bridged access
points. This can protect your wireless network.
Associated Clients
Click “Show Active Clients” button, then an “Active Wireless
Client Table” will pop up. You can see the status of all active
wireless stations that are connecting to the access point.
Wireless Site Survey
When you use this access point as a wireless station for wired
network device to have wireless capability, you have to
associate it will an working access point. Click “Select Site
Survey” button, then a “Wireless Site Survey Table” will pop up.
It will list all available access points near by. You can select one
access point in the table and it will join the wireless LAN
through this access point.
Click the Apply button at the bottom of the screen to save the above configurations. You can
now configure other advance sections or start using the Access Point.
Set Security
“Set Security” lets you setup the wireless security for the data transmission between the
bridged access points in “AP Bridge-WDS mode”. It provides “WEP 64bits”, “WEP 128bits”,
“WPA (TKIP)”, “WPA2 (AES)” encryption methods.
Parameter Description
Encryption
You can select “No encryption”,“WEP 64bits”, “WEP 128bits”,
“WPA (TKIP)” or “WPA2 (AES)” encryption methods.
Key Format
This is only used when you select “WEP 64bits” or “WEP
128bits” encryption method. You may choose to select ASCII
Characters (alphanumeric format) or Hexadecimal Digits (in the
To Next Page
Loading...
