44
1. Attach the end posts into the appropriate brackets on the
head and foot sections of the bed.
2. Place the overhead beam into the slots on top of each end
post.
NOTE: Be sure to place the holes facing upward on the overhead beam.
3. Insert the four 3/8” bolts (2 on each side) and tighten the nuts using a 9/16 wrench.
4. Attach the sliding saddle to the overhead
beam. Move the saddle until the pin is
secured into one of the holes on the overhead
beam.
5. Place the Clevis Pin through the sliding
saddle, securing the chain between the two
sides of the saddle, as shown in the picture.
6. After securing the trapeze bar, the saddle can
be repositioned into the appropriate location
without removing the Clevis Pin.
Tools required for assembly:
2-9/16” wrenches
To Next Page
Loading...
