EasyManua.ls Logo

SKF IMx-8 - Storage Capacity; Data Processing Memory; IMX-8 Certifications; IMX-8 Plus Certifications

SKF IMx-8
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRODUCT SPECIFICATIONS
SKF Multilog On-line System IMx-8/IMx-8Plus
SKF Multilog On-line System IMx-8/IMx-8Plus
User Manual
Revision E
49 (63)
o IMx-8Plus: RJ45 and Wi-Fi share a MAC address, not for
simultaneous use
o Support for Modbus TCP/IP (master and /or multiple slave instances)
o Support for IEC 61850 (communications networks in a sub-station
environment)
• GPS location data provided by an external GPS module (optional)
o Communication by Modbus RTU (see RS485 below)
o GPS with support for Satellite-Based Augmentation Systems
o Antenna is integral to the GPS module
• RS485 2-wire serial interface, Modbus RTU
o ‘RS485’ (top end cap) for Modbus sensor, GPS module, etc.
• USB Type-A (host interface) – fitted with an SKF Bluetooth dongle
o Bluetooth v4.0 Low Energy
• USB Mini-B (device service interface)
o Always use an isolated USB cable, CMON 4133 Mini USB cable
(isolated), to avoid ground loops when connecting to mains powered
equipment
3.2.10 Storage capacity
• 4 GB effective flash memory configured for pSLC (pseudo single level cell)
mode for higher reliability than normal MLC (multi-level cell) mode
3.2.11 Data processing memory
• 64 MB RAM for data processing
3.2.12 IMx-8 certifications
• Calibration traceable to BIPM
• CE certified in compliance with 2014/30/EU
• EMC immunity in compliance with EN 61000-6-2:2005
• EMC emission in compliance with EN 61000-6-4:2007/A1:2011
• DNV GL Renewables certificate – valid only when the IMx-8 DIN rail version
is mounted in an IP65 cabinet in a wind turbine that is built according to the
DNV GL wind turbine type approval
• DNV GL Marine type approval
• ABS Marine type approval
• Lloyd’s Register Marine type approval
3.2.13 IMx-8Plus certifications
Note that all IMx-8Plus certifications are pending.
• Calibration traceable to BIPM
• EMC, when the IMx-8 or IMx-8Plus is placed inside a metal outer enclosure:
o EN/IEC 61000-6-4, EN 50121-3-2, ETSI EN 301 489-1, -17
• CE certified:
o 2014/53/EU (RED) including ETSI EN 300 328, ETSI EN 301 908-1
• FCC certified (North America):

Table of Contents