Ski-Doo SKANDIC 600 (E) - DESS Key Programming via B.U.D.S.; Engine Oil Level Verification; Recommended Oil Types

FINAL PREPARATION
B.U.D.S. (Programing a DESS
Key)
A32A1Q6
Model(s): TUV Only
Read the content of the vehicle's MPEM by
clicking on READ DATA from the tool bar.
Click on the KEYS tabtoopentheDESSkeyspage.
Click on ERASE ALL KEYS.
Click on ADD KEY.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: A dialog box opens and asks you to
insert a key on the MPI DESS post.
IfthekeythatyouinsertedontheMPIDESS
post was successfully read and added to the
document, message box will appear.
Click on OK.
Repeat steps 3 to 5 for each DESS key you
want to program into the vehicle.
Write the document into the vehicle by clicking
on WRITE DATA from the tool bar.
Remove the GREY key from the vehicle DESS.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: If the B.U.D.S. system loses
communication while connected, press the
start/stop button or turn briefly the ignition switch
to the START position to reactivate communication.
Engine Oil Level
A29C2Y6
1 2
Model(s): TUV 4-TEC Only
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: These models are equipped with
4-stroke engine. Use XP-S
TM
0W40 synthetic
4-stroke oil (P/N 293 600 054).
CAUTION: Vehicle must be on a level surface
before checking any fluid level.
Make sure engine is at operating temperature
Leave engine running at idle for 30 seconds.
Stop the engine and wipe the dipstick.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Dipstick must be completely screwed
in before checking oil level.
Oil level must be between minimum [
[[
[2]
]]
]and
maximum [
[[
[1]
]]
] marks on dipstick.
Recommended Oil
Model(s): All Models except 4-TEC
CAUTION: Use only oil that flows at
-40°C(-40°F).
Oil is contained in the injection oil reservoir.
Use only two-stroke engine
injection oil, sold by BRP.
MODEL OIL TYPE
2-TEC SDI [1]
XP-S synthetic 2-stroke oil
or XP-S 2-stroke synthetic
blend
All others
XP-S synthetic 2-stroke oil
or XP-S 2-stroke
synthetic blend
or XP-S mineral
injection oil
18 / 24 2006-1 Predelivery