SET-UP
Handlebar
A29G0Q6
Model(s): Already Installed on Steering Column
Adjust handlebar and set both clamps to
have equal gap on each side.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Use handlebar wire hole as a
guide to center.
Master cylinder brake fluid reservoir
must be levelled.
Torque nuts from 24 N•m(18 lbf•ft).
2
A29G1B6
3
1
4
Model(s): To be Installed on Steering Column
Assemble handlebar with extension [
[[
[1]
]]
]and
clamps [
[[
[2]
]]
] on steering column.
Secure temporarily with:
– [
[[
[3]
]]
] 2 hexagonal bolts (predelivery kit)
– [
[[
[4]
]]
] 2 elastic nuts (predelivery kit).
Adjust handlebar and set both clamps to
have equal gap on each side.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Use handlebar wire hole as a
guide to center.
Master cylinder brake fluid reservoir
must be levelled.
MODELS TORQUE
SKANDIC SUV
24 N•m(18lbf•ft)
EXPEDITION
29 N•m(21lbf•ft)
Torque nuts from 24 N•m(18 lbf•ft).
Steering Pad
3
1
2
4
A29G156
Model(s): Steering Pad with Keyway
Loosen throttle and brake handle housings.
Install steering pad.
Adjust both throttle and brake handle housings
to match steering pad.
Secure steering pad [
[[
[1]
]]
] to handlebar with:
– 2 keyways [
[[
[2]
]]
]
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Useliquidsoaptoeaseinstallation
if necessary.
– 2 screws M5 x 20 [
[[
[3]
]]
]
– 2nutsM5[
[[
[4]
]]
].
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Item [
[[
[3]
]]
]and[
[[
[4]
]]
] seat tighten only,
no deformation of rubber.
Predelivery 2006-1 9 / 24
To Next Page
Loading...
