UNCRATING
A06F2Q6
Cut locking tie retaining hook.
Lay on seat and ask another person to apply
pressure onto rear bumper.
Remove hook from suspension.
WARNING
Before removing hook always verify that
vehicle is properly supported and that
parking brake is applied.
WARNING
Hook must be removed to have snowmobile
suspension operational.
Remove the vehicle from the crate base.
SET-UP
Battery Preparation
Model(s): All except LT
All electric starting equipped vehicles using a
YTX20L-BS or YTX24L-BS type battery require
a specific charging procedure at predelivery.
Follow the appropriate procedure as
described below.
WARNING
Always wear safety glasses and charge in
a ventilated area. Never charge or boost
battery while installed on vehicle. Do not
open the sealed caps during charging. Do
not place battery near open flame.
CAUTION: If battery becomes hot, stop charging
and allow it to cool before continuing.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Sealed VRLA batteries have an internal
safety valve. If battery pressure increases due to
overcharging, the valve opens to release excess
pressure, preventing battery damage.
An automatic charger is the fastest and most
convenient way for error-proof charging.
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: If battery cannot be recharged using the
following charging chart, replace battery.
Battery Voltage below 12.8 V
STANDARD CHARGING
(recommended)
BATTERY TYPE TIME CHARGE
YTX20L-BS 4 – 9 hours
YTX24HL-BS 5 – 10 hours
2A
QUICK CHARGING
BATTERY TYPE TIME CHARGE
YTX20L-BS
50 minutes
YTX24HL-BS
1 hour
10 A
Model(s): LT Only
During preparation, the battery can be
activated as described in last year appropriate
SKI-DOO SHOP MANUAL.
CAUTION: Prior to charging the battery,
always remove it from the vehicle to
prevent electrolyte spillage.
Battery Removal
A29E136
1
2
Model(s): TUV
N
NN
NO
OO
OT
TT
TE
EE
E:
::
: Battery is located under the seat.
Unhook battery cover strap [
[[
[1]
]]
] from its support.
Open battery cover [
[[
[2]
]]
].
Remove battery.
4 / 24 2006-1 Predelivery
To Next Page
Loading...