EasyManua.ls Logo

Ski-Doo SKANDIC 600 (E) - Brake Fluid Level Verification; Coolant Reservoir Level Check

Ski-Doo SKANDIC 600 (E)
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FINAL PREPARATION
Bleed the small oil lines between pump and
intake manifold by running engine at idle while
holding the pump lever in fully open position.
Model(s): TUV 600 HO SDI Only
Oil injection pump is factory set. However, if
adjustment needs to be checked or modified,
refer to the SERVICE BULLETIN 20058.
Brake Fluid Level
1
A06G1O6
Model(s): All except LT
Check brake fluid in reservoir for proper level [
[[
[1]
]]
].
Add brake fluid as required.
Use brake fluid:
SRF(DOT4)(P/N293600063)or
GTLMA (DOT 4) (P/N 293 600 062).
CAUTION: To avoid serious damage to the
brake system, use only DOT 4 brake fluid from
a sealed container. Do not use brake fluid
taken from old or already opened containers,
nor mix different fluids for topping off.
Coolant Reservoir Level
Model(s): Liquid Cooled Only
CAUTION: Vehicle must be on a level surface
before checking any fluid level.
Check coolant level in the overflow coolant tank.
When the engine is cold, the level must be
between minimum [
[[
[2]
]]
]andmaximum[
[[
[1]
]]
] marks.
Use Bombardier premix coolant (P/N 219 700 362)
or a blend of 50/50 distilled water and
ethylene-glycol .
CAUTION: To prevent rust formation or
freezing conditions, always use ethylene glycol
antifreeze containing corrosion inhibitors
specially recommended for aluminum engines.
Always use 50% antifreeze and 50% water for
this particular type of snowmobile.
Track Adjustments
Refer to SHOP MANUAL and to TECHNICAL
DATA section at the end of this bulletin to
adjust track tension and alignment.
Brake Disk
Remove any rust built-up on braking surfaces.
Clean brake disk with pulley flange cleaner
(P/N 413 711 809).
Driven Pulley
Model(s): All except LT
It is usual to experience spring settings during
break-in period of a new spring.
The factory spring preload is slightly higher
to compensate for springs settings.
Specifications in TECHNICAL DATA are applicable
after break-in period (about 10 hours of use).
DELIVERY TO CUSTOMER
Predelivery Check List
Make sure to complete the Predelivery Check
List before delivering the vehicle.
20 / 24 2006-1 Predelivery

Related product manuals