120
NOTE: Apply wax on glossy finish only. Protect the vehicle with a cover
to prevent dust accumulation during storage.
CAUTION: The snowmobile has to be stored in a cool and dry place
and covered with an opaque tarpaulin. This will prevent sun rays
and grime from affecting plastic components and vehicle finish.
Lift rear of vehicle until track is clear of the ground. Install on a wide-
base snowmobile mechanical stand.
NOTE: Do not release track tension.
Belt Guard Removal and Installation
1. Turn off engine cut-out switch. Open hood.
2. Open retainer to release pin then pull belt guard out of vehicle.
TYPICAL
1. Pin retainer
WARNING
Engine should be running only when belt guard is secured in
place.
1
A32C05A
Mmo2003-003a.book Page 120 Tuesday, March 19, 2002 2:22 PM
To Next Page
Loading...
