139
Headlight Beam Aiming
Turn knob to adjust beam height.
TYPICAL
1. Knob
Bulb Replacement
Always check light operation after bulb replacement.
Headlight
CAUTION: Never touch glass portion of an halogen bulb with
bare fingers, it shortens its operating life. If glass is touched,
clean it with isopropyl alcohol which will not leave a film on the
bulb.
If any headlight bulb is burnt, remove windshield and unplug burnt bulb
connector. Remove the rubber boot.
A32E01A
1
Mmo2003-003a.book Page 139 Tuesday, March 19, 2002 2:22 PM
To Next Page
Loading...
