THE PULSE OUTPUT
A single pulse output is available. This pulses at a rate proportional to the
longitudinal speed. (This is the required output for RADAR systems). The pulse
is active high and the pulse length is 60 ms. This output is located on pin 9 and
10 on connector J301 and is attached to an optocoupler. To get a signal from
this port, a voltage must be applied to pin (XXXXX) A (5-24 V). (The same as
t-out).
THE DIMMING INPUTS
Pulses of at least 60 ms on the dimming up and dimming down inputs (J400
pins 5, 6, 7) will cause the dimming to change by one level. The inputs are
optocoupled and therefore require an external voltage to operate, (4 Volt -30
Volt (typically 12/24 Volt)).
Note: If the system is set up as CD401EB/DB, the dimming input (DIMUP/COM)
are used for changing the speed direction and remote dimming is not possible.
To Next Page
Loading...