Skipper EML224 - Menu Diagram

OpInMan EML224/DL1 Compact Speed Log System
Page 28 of 68
Date: 2017-01-12
Electronics AS
Calibration (CALIB)
Calibration of Speed Log
Systems
▲ Next sub menu
▼ Prev sub menu
SET Select sub menu
MENU Return
Manual calibration
(MANUL)**
▲ Increment underlined digit
▼ Decrement underlined digit
SET Move to next parameter
10 available speed parameters
and 1 offset
Semi automatic calibration
(AUTO)**
▲ Increment underlined digit
▼ Decrement underlined digit
SET Move to next parameter/
action
Graph (GRAPH)
▲ Increment cal point
▼ Decrement cal point
SET view/change parameter
System setup (SETUP)
Setup the system parameters
▲ Next sub menu
▼ Prev sub menu
SET Select sub menu
MENU Return
MENU DIAGRAM
NMEA outputs (NMEA)*
▲ Move to next message
▼ Move to previous message
SET Turn on/off current
message
Pulse outputs (PULSE)
▲ Next preset value
▼ Previous preset value
Changes the number of pulses
per nautical mile (longitudinal)
Time averaging (AVRGE)
▲ Increment pulses
▼ Decrement pulses
Changes the number of pulses
to be averaged over
Baud settings (BAUD)
▲ Higher value
▼ Lower value
SET Move to next port
* One option in the NMEA settings is DIAG. This turns on some of the diagnostics
outputs. These are proprietry messages that occur if an error occurs or if
requested. Setting this to ‘ON’ will stop all other messages.
** Offset calibration not available in single axis system.
*** DL conguration: only available on DL1 system.
Menus
Scrollable menu system. Accessed with
SET and MENU pressed simultaneously
▲ Next sub menu
▼ Prev sub menu
SET Select sub menu
MENU Return
Water temperature offset
(TEMP)
▲ Increment temperature
offset
▼ Decrement temperature
offset
DL conguration
(DL-CFG)***
▲ Higher (deeper) preset
▼ Lower (shallower) preset
(default is 2)