Skipper ESN100 - Page 40

Page 40 of 56
SKIPPER Electronics AS
Edition: 2021-09-16
ESN100 Operation and Installation Manual
Chapter: ESN100 Screen functions
Other information can be shown on the side parameter, these are from the NMEA inputs or from other sys-
tems connected via LAN. (e.g. DL2 speed sensor)
ese include:
- Auto
Alert Deep e value when a deep water alert or warning will
sound
Dra e distance from the surface to the lowest point of
the keel
Depth below surface e depth value from surface to the bottom
Depth below keel e depth value from the lowest point of the hull
Depth below transducer e depth value to the bottom from the face of the
transducer
Speed from GPS Speed over ground from a connected GPS
Speed from LOG Speed over ground from a connected log
STW from log e Speed through water from a connected log
Rate of turn e Rate of turn from a connected gyro
Depth from Log e depth measured by the log sensor
All adjustments are available from the menus by pressing Cong
Depending on which transducers are connected, the user can switch between transducers or frequency using the
navigate arrows. The current transducer frequency and posion is shown in the text under the depth.