sks BS2012 - Deleting All Call Addresses

33
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: support@sks-kinkel.de
Version No. 3.0
Document No. 97000104
SKS-Kinkel Elektronik GmbH
20002110 BS2012 Audio Hands-free
EN
Step Image Description
6
+
Keep hold of the programming button on the back of the device and also
keep hold of the S-key within two seconds. Hold both keys at the same
time for ve seconds until a signal tone is heard. Thus the S-key has
been assigned to the internal call address B2, i. e. when pushing the
S-key, indoor station 2 will be called.
7
B3
Set the DIP switch to the internal call address (= internal call address of
indoor station 3, saved on the light key, in the example above B3), this
will be called by pushing the respective bell button at the door station.
8
+
Keep hold of the programming button at the back of the device and, with-
in two seconds, also keep hold of the light key. Keep hold of both keys
for ve seconds until you hear a signal sound. Thus the light key has
been assigned to the internal call address B3, i. e., when the light key is
operated indoor station 3 will be called.
Attention
We recommend setting the DIP switch back to the main call address (= rst call ad-
dress programmed) after the programming is nished, so that it can easily be rec-
ognized which bell button belongs to which indoor station in case of a breakdown.
After programming the rst indoor station go on programming indoor stations 2 and 3 in the same way.
8.5 Deleting all call addresses
A single call address can not be deleted, all call addresses are deleted at once. To do so
keep hold of the programming key for 25 seconds, during which various signal tones are
audible.
Deleting is nished when you hear a high signal tone lasting three seconds.
Attention
After deleting all programmed call addresses only the one call address set at the DIP
switch is e󰀨ective.