SNR - Signal Noise Ratio, the ratio of signal power to the noise power, expressed in decibels.
RSSI - Received Signal Strength Indication, a measure of the energy observed by an antenna when receiving a signal
It's recommended to keep output TX power for both air and ground module at low values when working with the system. 7 dBm is minimum
and recommended value. Use higher values when flying. Using high values over long time near human body might cause health problems
due to radiation.
After changing any parameter click Save . It might take a few seconds until changes applied. The system may loose connection when changing
any parameter.
Changing Security settings
Security tab allows you to assign network name and encryption key. Connection is AES encrypted.
Make sure that both air and ground modules have the same network name and encryption key. Otherwise, the modules are not considered to
be paired and won't connect to each other.
To Next Page
Loading...
