Sky-Drones SMARTAP PDB - Firmware Update; Latest Firmware Installation

Drivers installation
Getting the software
Firmware update
Latest firmware installation
Custom firmware upload
Getting the log
General configuration
Standard PID presets
Updating GNSS Module
Flashing Bootloader
Flashing DFU (old)
Firmware update
NO BATTERY, USB CONNECTION ONLY!
Do not connect the main battery for the steps below. Use USB connection only!
Latest firmware installation
If you can see exclamation mark icon when pulling out the Drawer it means that there is firmware update available.
Introduction
SmartAP PRO
SmartAP MAX
SmartAP PDB
SmartAP GNSS
SmartLink
Autopilot configuration
Flying
Support
Revision history
SmartAP AutoPilot User’s Guide Firmware update
Sky-Drones - SmartAP Flight Control Systems 92 / 151