Skyjack SJ6832 RTE - 16 Do a Test of the Lowering Warning System; 17 Do a Test of the Elevated Travel Speed

45
SJ6832 RTE
221844ACAI
Function Tests Section 4 – Inspections Before Operation
4.3-16 Do a test of the lowering warning
system
1. Squeeze and hold the function-enable switch
2
.
2. Push the controller handle
3
to raise the
platform to a height of approximately 3 to 4 m.
3. Pull the controller handle to lower the platform.
▪
Result: The platform starts to lower but stops
at a height of approximately 2.5 m. An alarm
makes a sound.
4. Release the function-enable
2
switch and the
controller handle
3
.
5. Make sure that the area around the MEWP is
clear.
6. Squeeze and hold the function-enable switch
2
.
7. Pull the controller handle
3
to continue to
lower the MEWP.
▪
Result: The platform fully lowers.
4.3-17 Do a test of the elevated travel
speed
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
1. Make sure the path of intended motion is clear.
2. Raise the platform until it is at a height of
approximately 4.3 m.
3. Drive the MEWP forward and then rearward.
▪
Result: The MEWP drives slower than when it
was in the lowered travel position.
1
2
3