84
SJ6832 RTE
Section 8 – Labels Electrical compartment
Description Label Pictorial
1
Base control console
Accumulated operating time.
Battery level.
Error codes. Refer to the Service manual for error codes.
Select the AUTO position to activate HPP in automatic mode.
Select the M position to activate HPP in manual mode.
Select the on position to start the HPP (if equipped). Select the
off position to turn off the HPP.
Read the operation manual.
Push to reset ground posicircuit breaker.
Push to reset power circuit breaker.
Push to disable controls (emergency stop). A light indicates the
controls are enabled.
Select to raise or to lower the platform.
Select to enable platform controls, or to enable the base control
console.
Select the off position to disconnect power to all circuits. Select
the on position to operate any circuit.
1
8.1 Electrical compartment
To Next Page
