Skyjack SJ6832 RTE - Unfold the Guardrail System up

73
SJ6832 RTE
221844ACAI
Fold the guardrails Section 6 – Additional Procedures
22. Use the MEWP ladder to exit the platform.
WARNING
Fall hazard. Fully lower the platform before you
fold or unfold the guardrails. If you do not obey,
there is a risk of death or serious injury.
6.8-2 Unfold the guardrail system up
1. Make sure that the MEWP is on level ground.
2. Make sure that the extension platform is fully
retracted.
3. Push the emergency-stop button on the base
control console.
4. Turn the Main power disconnect switch to the off
position.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
and exit the platform. If you do not obey, there is a
risk of death or serious injury.
5. Use the MEWP ladder to enter the platform.
6. Close the gate.
WARNING
Fall hazard. To prevent a fall, keep away from the
sides of the platform when you fold or unfold the
guardrails. If you do not obey, there is a risk of
death or serious injury.
WARNING
Fall hazard. Install each lock-pin correctly with
the detent ball of each lock-pin fully through the
guardrail. The guardrail system must be in the
vertical position. An incorrectly locked guardrail
can cause a fall, which can cause death or serious
injury.
7. Unfold the entrance side guardrail.
8. Put in all locking pins to lock the entrance side
guardrail in position.
9. Unfold the left side guardrail.
10. Put in all locking pins to lock the left side
guardrail in position.
11. Unfold the right side guardrail.
12. Put in all locking pins to lock the right side
guardrail in position.
13. Unfold the left-side extension guardrail.
14. Put in the locking pin to lock the left-side
extension guardrail in position.
15. Unfold the right-side extension guardrail and the
front guardrail.