67
SJ6832 RTE
Use the platform control console from the ground Section 6 – Additional Procedures
6.5-3 Drive and tie-down the MEWP
Before you drive the MEWP:
▪
The ramp or dock capacity must be able to hold
the maximum MEWP weight.
▪
Use side guards (if available) to prevent a fall
from the ramp.
▪
The incline of the ramp must not exceed the
MEWP gradeability. Refer to section 7.3.
▪
Do a test of the MEWP brakes to make sure they
operate correctly.
▪
Move the inclined-drive/level-drive switch to the
inclined-drive (low speed/high torque) position.
WARNING
When you transport the MEWP, it must be attached
to a truck or trailer deck. Use the available
tie-down points
3
to attach the MEWP. Refer to
Figure 07. If you do not obey, there is a risk of
death or serious injury.
▪
Tie-down the MEWP to the transport vehicle
using the tie-down points
3
. Refer to
Figure 07.
6.6 Use the platform control
console from the ground
WARNING
The correct operator location is with the platform
control console attached to the right-front side
of the platform. Only operate the MEWP from the
ground in these conditions:
▪
To do maintenance
▪
When you cannot do work safely from the
position of the operator on the platform
because of an obstruction
▪
To fold the guardrails.
If you do not obey, there is a risk of death or
serious injury.
6.6-1 Disconnect and remove the
platform control console
1. Disconnect the platform control console cable
from the electrical plug under the platform.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
2. Use the MEWP ladder to enter the platform.
To Next Page
