Page 2
ELECTRICAL REQUIREMENTS
This fixture requires that electrical connections are made by a licensed electrician in accordance with
state, local and national electrical codes using UL (Underwriters Laboratory) recognized materials.
Do not turn on main power to fixture until all lightheads are installed, connections are complete and
the fixture has been reviewed by a SKYTRON representative.
ELECTRICAL HAZARDS EXIST!
Excercise caution when working on this fixture, the installation of this fixture must be made only by
qualified and authorized personnel familiar with the essential knowledge and techniques.
CONNECTION MEANS
CAUTION
Connection of the fixture wires must be made using crimp connectors. Main terminal devices shall be
so located or shielded that, should a wire of a stranded conductor escape when the conductors are fit-
ted, there is no risk of accidental contact between live parts and accessible parts. Acceptable sheilding
methods include UL aproved shrink tubing and electrical tape.
NATIONAL ELECTRICAL CODE, NFPA & ANSI REQUIREMENTS
The installation of connecting cords between equipment parts shall meet the requirements of the Na-
tion Electrical Code, ANSI/NFPA70 as applicable.
BENDING REQUIREMENTS
Connection leads shall be constructed in such a manner that moveable leads in normal use are not
bent around a radius of less than five times the outer diameter of the lead concerned. Avoid conditions
employing severe bends to ensure the integrity of conductors.
To Next Page
Loading...
Need help?
General
