120
Fig. 86
Generally applicable titration parameters
Depending on the titration mode (dynamic, linear and end-point titration), it is possible to enter a
variety of parameters. The following parameters are valid for all automatic titration modes:
Measured value (pH, mV)
Measurement speed
Initial waiting time
Pre-titration
Titration end
But please note that the measurement speed and the titration end differ again as a function of the
respective titration mode.
<Measured value> is the first selection to be made. In the present example, the selection is “pH“.
Fig. 87
The selected measured value is displayed for information.
Fig. 88
To Next Page
Loading...