SMA Solar Technology AG Electrical Connection
Installation Guide SB20_25_30HF-IEN102911 47
4. Push the threaded joint to the thread and screw into place.
☑ The DC plug connectors are now assembled and can be connected to the inverters, as
described in section 6.3.4”Connecting the PV Generator (DC)” (page49).
☑ If the conductors are not visible in the
hollow cavity, the cable is not in the correct
position.
• Loosen the clamping clip using a
screwdriver.
The width of the screwdriver should be
3.5 mm.
• Remove cable and start again from step 1.
Result Action
To Next Page
Loading...
