Mounting Mounting Procedure
3-8 SMA America SB3000US-4000US-11-SE1607
Alternatively the Sunny Boy can be mounted on a DIN Rail:
Figure 3-7 Sunny Boy with Mounting Bracket on DIN Rail
Use the following procedure to mount the wall-mounting bracket:
1. Locate the T-shaped wall-mounting bracket included in the shipping container
with the Sunny Boy.
2. Position the wall-mounting bracket against the wall where you intend to mount
the Sunny Boy. (Try to mount the Sunny Boy so that the display is
approximately at eye-level.) Place a level on the top edge of the bracket, and
adjust the position of the bracket until it is level. The bottom of the bracket will
be the approximate location of the bottom of the inverter.
3. Using the wall-mounting bracket as a template, mark the wall through at least
two holes in the horizontal or vertical portion of the bracket.
CAUTION: Ensure that there are studs in the wall at the plac-
es where you intend to drill the mounting-holes. DO NOT use
molly or toggle bolts to mount the Sunny Boy to sheet rock or
panelling.
4. Set the bracket aside temporarily, and drill holes at the marks you made on the
wall.
To Next Page
Loading...
