Displays and Messages Status Messages on the LCD
SB3000US-4000US-11-SE1607 SMA America 7-13
Fault Messages
In case of a fault condition the LCD switches to “Fault“ mode and the backlight is
activated.
The upper display line indicates one of the three following failure types:
• Disturbance
For example, this Disturbance message would be dis-
played if the Sunny Boy detected a problem with the fre-
quency of the utility grid. The message would clear
automatically once the condition was corrected. Distur-
bances are typically caused by a measured value ex-
ceeding a predetermined limit.
The display will show the value of the error (at:) as well
as the present value for the particular parameter
(present:).
• Warning
For example, this Warning message would be displayed
if the GFDI fuse was open or cleared. Typically, Warning
messages indicate a system condition that should be in-
vestigated. Warning conditions will not preclude inverter
operation.
• Error
For example, this Error message would be displayed if
the inverter detected a problem with the internal ROM.
An Error condition will prevent the inverter from restarting
until the condition is cleared.
Note: Each fault message is displayed for 5 seconds. After
5 seconds, the LCD will once again scroll through its normal
operating screens. The fault condition will be included in the
series of screens until the condition is cleared.
Disturbance Message
Disturbance
Fac-Bfr
Disturbance Details
at: 59.29Hz
present: 59.30Hz
Warning Message
WARNING
GFDI Fuse Open
Error Message
Error
ROM
To Next Page
Loading...
