SMA America, LLC 7 Configuration
Installation Manual SB30-40-US-IA-en-33 55
7.4 Changing the Display Language
You can change the display language of the inverter. The language is configured via two switches
that are located on the bottom edge of the display.
Figure 24: Switch for setting the language on the bottom edge of the display
1. Open the inverter (see Section 9.1).
2. Set the desired language using the two rotary switches:
3. Commission the inverter (see Section 8).
Position Designation
A"S2" switch
B"S1" switch
Language Switch S2 Switch S1
German B B
English B A
French A B
Spanish A A
To Next Page
Loading...
