docs.smarttech.com/kb/171897 34
Power state commands
Get command Set command Response
get powerstate set powerstate[Value]
Where [Value] is one of the following:
l
=on
l
=standby
l
=off
powerstate=[Value]
Where [Value] is one of the following:
l
on
l
standby
l
off
See alsosupport.smarttech.com/docs/energysavingmodes
Input commands
Get command Set command Response
get input set input[Value]
Where [Value] is one of the following:
l
=hdmi1
l
=hdmi2
l
=hdmi3
l
=hdmi4
l
=vga1
l
=ops1
l
=usbc1
l
=usbc2
l
=android
input=[Value]
Where [Value] is one of the following:
l
hdmi1
l
hdmi2
l
hdmi3
l
hdmi4
l
vga1
l
ops1
l
usbc1
l
usbc2
l
android
Brightness commands
Get command Set command Response
get brightness set brightness[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[0–100]
brightness=[Value]
Where [Value] is a number between 0
and 100
Appendix A Managing the display using RS-232
To Next Page