APPENDIX C
REMOTELY MANAGING THE DISPLAY
104 smarttech.com/kb/171167
Audio
Use the following commands to identify audio settings.
Command Response Possible values Standby
mode
get volume volume=[Value] 0–100 No
get mute mute=[Value] on
off
No
get audioinput audioinput=[Value] usbaudio
HDMI
OPSdigital
No
get treble treble=[Value] 0–100 No
get bass bass=[Value] 0–100 No
get audioeq120 audioeq120=[Value] 0–100 No
get audioeq500 audioeq500=[Value] 0–100 No
get audioeq1200 audioeq1200=[Value] 0–100 No
get audioeq7500 audioeq7500=[Value] 0–100 No
get audioeq12k audioeq12k=[Value] 0–100 No
get balance balance=[Value] 0–100 No
Use the following commands to assign audio settings.
Command Possible values Response Standby
mode
set volume [Value] + [Incremental value]
- [Incremental value]
=0–100
volume=[Value] No
set mute [Value] =on
=off
mute=[Value] No
set audioinput [Value] =usbaudio
=HDMI
=OPSDigital
audioinput=[Value] No
set treble [Value] + [Incremental value]
- [Incremental value]
=0–100
treble=[Value] No
set bass [Value] + [Incremental value]
- [Incremental value]
=0–100
bass=[Value] No
set audioeq120 [Value] =0–100 audioeq120=[Value] No
set audioeq500 [Value] =0–100 audioeq500=[Value] No
set audioeq1200 [Value] =0–100 audioeq1200=[Value] No
To Next Page
Loading...
Need help?
General
