Chapter 3
23 smarttech.com/kb/171167
Chapter 3: Connecting power and devices
Connecting power 24
Connecting to a network 24
Connecting cables for room computers, guestlaptops and other input sources 25
Using recommend cables 25
Connecting to the display 26
Viewing a connected computer or other device’s input 26
Connecting external speakers 26
Connecting other devices 27
Connector reference 28
iQ appliance 28
Connectorpanel 29
Connect the display to power after you install it but before you turn it on for the first time and
configure the iQ appliance. You can also connect cables for room computers, guest laptops or
other input sources as well as for speakers and other devices.
By installing cables in advance, you make use of connectors that might not be accessible after the
display is wall-mounted. You can then run the cables across floors or behind walls as needed.
WARNING
Ensure that any cables that cross the floor to the display are properly bundled and marked to
avoid a trip hazard.
To Next Page
Loading...
Need help?
General
