IMPORTANT INFORMATION
iii smarttech.com/kb/171167
IMPORTANT
l The following are the normal operating power requirements for the display:
Model Power requirements
SPNL-6055 90V to 240V AC, 50 Hz to 60 Hz, 130 W
SPNL-6065 100V to 240V AC, 50 Hz to 60 Hz, 200 W
SPNL-6065-V2 100V to 240V AC, 50 Hz to 60 Hz, 110 W
SPNL-6075 100V to 240V AC, 50 Hz to 60 Hz, <131 W
SPNL-6265-V2 100V to 240V AC, 50 Hz to 60 Hz, 113 W
SPNL-6275 100V to 240V AC, 50 Hz to 60 Hz, 190 W
SPNL-6065P 100V to 240V AC, 50 Hz to 60 Hz, 110 W
SPNL-6075P 100V to 240V AC, 50 Hz to 60 Hz, <131 W
SPNL-6265P 100V to 240V AC, 50 Hz to 60 Hz, 113 W
SPNL-6275P 100V to 240V AC, 50 Hz to 60 Hz, 190 W
l For additional requirements and other information, refer to the display’s specifications (see
More information on page10).
Federal Communication Commission
interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
5.15–5.25 GHz frequency band operation is restricted to indoor use only. Outdoor operations in the 5150~5250 MHz are
prohibited.
To Next Page
Loading...
Need help?
General
