CHAPTER 6
ORIENTING AND CALIBRATING THE DISPLAY
51 smarttech.com/kb/171167
To calibrate the display when connected to a computer
1. Open SMART Settings:
Operating
system
Procedure
Windows 10
a.
Select Start.
b.
Scroll to and select SMART Technologies > SMARTSettings.
Windows 8
a.
Open the Apps screen.
b.
Scroll to and select SMART Technologies > SMARTSettings.
Windows 7 Select Start > All Programs > SMART Technologies >
SMARTTools>SMARTSettings.
macOS
a.
Press the SMARTBoard icon on the Mac menu bar.
b.
Press SMARTSettings.
SMART Settings appears.
2. Press SMART Hardware Settings.
3. If more than one SMART product is connected to your computer, select the display.
4. Select Advanced Settings from the drop-down list.
5. Press Calibrate, and then follow the on-screen instructions.
The calibration screen appears. This can take a few moments.
6. Press the red target with the tip of a pen. Hold the tip at the center of the target until the target
turns green, and then lift the pen.
The target moves to the next location.
NOTE
You can calibrate a target again by pressing the LEFT ARROW key on your keyboard.
To Next Page
Loading...
Need help?
General
