Decreasing the blower speed
X
Press the I button.
Switching air-recirculation mode on/off
X
Press the À button.
The indicator lamp above À lights up
when air-recirculation mode is activated.
Switching "Cooling with air dehumidifi-
cation" on or off
The "Cooling with air dehumidification"
function cools and dehumidifies the air
inside the vehicle during warm weather.
The engine must be running in order to use
"Cooling with air dehumidification".
X
To switch on: press the K and
¿ button.
The indicator lamp below ¿ lights up
when the function is activated.
In damp weather, only switch off the "Cool-
ing with air dehumidification" function
briefly. Otherwise the windows can mist up
more quickly.
Demisting the windscreen
X
Press the ¬ button.
The indicator lamp above ¬ lights up
when the windscreen is being demisted.
Use this setting only until the windscreen
is clear again.
Demisting the rear window
When the rear window heating is activated,
the exterior mirrors are also heated.
X
Press the ¤ button.
The indicator lamp above ¤ lights up
when the rear window heating is activa-
ted.
Use this setting only until the rear window
is clear again.
Drying windows that are misted up on
the inside
X
Press the ¿ button.
X
Press the à button.
X
If the windows are still misted up, press
the ¬ button.
Use this setting only until the windows are
clear again.
Drying windows that are misted up on
the outside
X
Switch on the windscreen wipers.
X
Press the ¬ button.
Use this setting only until the windows are
clear again.
Setting the pre-entry climate control at
departure time using the on-board
computer
Only for instrument cluster with colour dis-
play:
The "Pre-entry climate control at departure
time" function heats or cools the vehicle
interior before the scheduled departure
time. The climate control runs until approx.
10 minutes after the set departure time.
The vehicle must be connected to the
charger in order to activate pre-entry cli-
mate control. The battery charge status and
the charge output of the high-voltage bat-
tery must be sufficient.
If pre-entry climate control cannot be
operated, a display message is shown in the
on-board computer.
X
Call up Pre-heat/cool and charge in
the on-board computer.
X
Press a.
X
Select the setting.
The following settings can be selected:
R
No pre-selection
The pre-entry climate control is deac-
tivated.
R
Two stored departure times
X
Select Departure time > Activate to acti-
vate the stored departure time. If Smart-
Charging was selected before, this set-
ting is also activated.
98
Operating the climate control system
>> Feeling comfortable in the vehicle interior.
To Next Page
Loading...
Need help?
General
