R
2: All seats occupied and luggage com-
partment laden
R
3: Driver's seat occupied and luggage
compartment laden
Adjusting the dipped-beam head-
lamps to left-hand or right-hand
traffic
The symmetrical dipped-beam headlamps
are required when travelling in countries
where vehicles are driven on the opposite
side of the road to that in which the vehicle
is registered. Unlike the asymmetrical
dipped-beam headlamps, these headlamps
do not dazzle oncoming traffic. Symmetrical
dipped-beam headlamps provide less illu-
mination to the edge of the carriageway.
X
Open the service cover.
X
For symmetrical dipped beam: turn the
screws of both headlamps as far as they
will go to position ±.
For asymmetrical dipped beam: turn the
screws of both headlamps as far as they
will go to position q.
X
Have the dipped-beam headlamp setting
checked at a qualified specialist work-
shop.
Using the interior lighting
Switching the interior lighting on and
off
The interior lighting goes on when you
unlock the doors.
The interior lighting switches off in the fol-
lowing situations:
R
A door is opened and 15 minutes have
passed.
R
All doors are closed, the vehicle has been
locked and 15 seconds have passed.
R
All doors are closed, the vehicle has not
been locked and 4 minutes have passed.
R
The engine has been started.
The interior lighting can be activated when
a door is open. After closing the doors, the
interior lighting goes out.
X
Press switch : to switch the left-hand
reading lamp on and off.
X
Move switch ; to the desired position.
The following settings can be selected:
R
Interior lighting is switched on.
R
Interior lighting controlled automati-
cally.
R
Interior lighting is switched off.
X
Press switch = to switch the right-hand
reading lamp on and off.
Adjusting the ambient lighting (colour
display)
On-board computer with colour display: the
ambient lighting is set in the on-board
computer (Y page 114).
Using the interior lighting
91
>> Ensuring good visibility.
Z
To Next Page
Loading...
Need help?
General
