SMART high line radio - Selecting a Station Using the Waveband Scan; Selecting Channels Via the Channel Presets; Selecting Stations by Entering the Frequency Manually

Example: radio display
:
The status bar shows the current
waveband, clock and additional
displays
;
To switch radio mode off
=
Display/selection window with station
name and station frequency (line 1),
radio text display (line 2), waveband
(line 3) and assignment of the first four
presets (line 4)
?
To call up the settings menu
A
Station search, forwards/backwards
B
To call up a station preset
To switch radio mode off
X
Press ; in the radio display.
The main function active last is shown.
Switching wavebands
X
Press symbol ? in the radio display.
The settings menu appears.
X
Press Band in the menu. The entry on the
right beside Band shows the current
setting.
A list of available wavebands is shown.
You can choose from wavebands FM, FMT, FM
Dynamic, AM, or AMT.
FMT, AMT: Each waveband contains 12
stations that were automatically stored by
the Travelstore function, sorted by signal
strength (Y page 68). The strongest
station is stored as Preset 1. When you next
use this function, the current preset
stations are overwritten.
FM dynamic: while the vehicle is in motion,
the tuner scans regularly and stores the 32
stations with the best reception quality. It
is not possible to store a station manually.
Dynamic updating can cause a stored
station to change preset position in the
list.
X
Press 9 or : to scroll in the list.
X
Press the desired waveband.
Waveband Frequency
FM, FMT, FM
Dynamic
87.7 - 107.9 MHz
AM, AMT 530 – 1710 kHz
Selecting a station
Selecting a station using the station
search function
X
Press û or ü in the radio display
(Y page 65).
The needle jumps left or right in the
waveband and stops at the next station
with adequate reception.
66
>> smart high line radio.