SMART high line radio - Quick Menu (Expert Mode)

X
Press Immediately or another selection
option to determine when the block
should start.
The route section is blocked. The route
is recalculated.
X
To delete blocks: press 1 at the bottom
right in the "Length of avoided route"
list.
Starting route simulation
X
Press Simulation mode in the "Route
information" menu (Y page 42).
The route is shown from the start (or
previous position) to the destination.
Displaying trip info
X
Press Trip info in the "Route
information" menu (Y page 42).
You see the following information:
R
maximum speed
R
average speed
R
distance covered
R
driving time
R
total remaining driving time
R
total remaining journey distance
The bar underneath shows the following
information:
R
current height above sea level
R
current time (if route guidance is not
active)
R
remaining time to next destination
(intermediate stop, final destination)
R
remaining distance to next
destination (intermediate stop, final
destination)
R
estimated time of arrival at next
destination (intermediate stop, final
destination)
X
To close trip info: press &.
i
The information can also be shown by
pressing the field with the destination
information at the bottom of the map
(Y page 39).
Editing a route
Introduction
You can add additional destinations to the
route, optimize route guidance or change
the order of the destinations.
X
Press the arrow at the bottom left of the
map (Y page 39).
The navigation main menu appears.
X
Press Edit route.
The edit route menu appears.
The following functions can be selected:
R
adding a destination
R
optimizing a route (available with four
or more destination entries)
R
changing the order of the destinations
within the route
R
loading/saving a route
>> smart high line radio.
43
Z