Smartgen GENSET CONTROLLER MGC310

MGC300 Genset Controller User Manual
MGC300 Genset Controller Version 1.1 2020-01-04 Page 21 of 27
8 CONTROLLER PARAMETER SETTINGS
a. Under standby status, press at the same time, it will enter password entry
screen (Fig. 4). At this moment the first digital flashes.
Fig. 4 Password Entry Screen
b. Press and the flashing number adds 1; Press and it decreases 1. After correct
setting, press / to move.
c. After the password is passed it will enter parameter setting screen (Fig. 5). At this moment it
displays the serial number of the setting item and the set value. Press and the setting item
goes down; Press and the setting item goes up.
Fig. 5 Parameter Setting Screen
d. Press / and it enters the setting status of the current parameter value. At this time
the first digital number is flashing and the setting method is same as Step a;