SmartLine SL1620 - Totl Run; Clr Totl; Clr Def; Rain Dly

18
http://support.weathermatic.com
If you wish to reduce the deficit numbers, press and hold down
either the UP or DOWN button for 5 seconds. This allows you to
use the DOWN button to reduce the latest deficit for the zone to
as low as 0 inches.
Deficit is only available for review when you are using SMART
mode.
6.3.5 Totl Run
TOTL RUN is the total run time for each zone since the date
shown (default date in the SmartLine® controller is January 1,
2000 shown as 01/01/00). You can review TOTL RUN for either
the BASIC or SMART modes. After you select TOTL RUN with
the UP button, use NEXT to view the date when TOTL RUN
accumulation began. Use NEXT again to view the total run times
for each zone.
You can use the NEXT and BACK buttons to move through the
zones. After you go through all the zone positions, use the NEXT
button one more time to take you back to the TOTL RUN screen.
6.3.6 Clr Totl
CLR TOTL is used to clear and reset the total run time for each
zone shown in the TOTL RUN menu.
From the CLR TOTL menu, press NEXT and the display will
show KEEP. If you want to clear the TOTL RUN time and reset
the accumulation date, press either the UP or DOWN button to
display CLEAR. With CLEAR showing in the display, either press
NEXT or BACK or turn the dial to complete the clearing and
resetting. This feature will stop accumulations on a zone after
255 hours of cumulative zone run time.
6.3.7 Clr Def
To clear deficits, press NEXT. Use UP or DOWN buttons to select
KEEP or CLEAR. Press NEXT or BACK to exit CLEAR DEFICITS.
6.4 Rain Dly
The rain delay feature allows user to globally suspend watering
operations for all programs for a selected number of days in
either the BASIC or SMART watering modes.
Use UP or DOWN buttons to select 1 to 14 days for watering
suspension. The watering blackout will automatically be cleared
from the SmartLine® controller after the assigned days have
expired and watering will resume at the next available start time.
SMART watering deficits will reset at zero andwill not resume
accumulation until the delay has ended.
6.5 Slw
SLW incorporates 3 three features:
DELAY: This feature allows the user to adjust the factory set 48
hour watering delay that will occur after a rain event shutdown if
you are using an SLW Weather Sensor for SMART Watering. To
eliminate the delay or to reduce or increase the factory default
hours, turn the dial to Advanced Menu and use an arrow button
to select SLW DLY. Press the NEXT button and 48 hours will
show in the display. Use the UP and DOWN buttons to eliminate
the delay or to select a dierent number of hours (0–99 hours).
Note: The SLW DLY begins after the SLW rain sensor has reset
following a rain event. Accumulation of new water deficits will
not begin until after the SLW DLY has cleared.
Advanced Menu 6.0