SmartLine SL1620 - Default; Troubleshooting 7.0; Total Master Reset Procedure for the Smartline Controller

22
http://support.weathermatic.com
of your grow in, the controller will automatically retrieve the
long-term program stored in Step 2. Return dial to Run.
6.19 Default
This is an optional function that allows the user to store a
program that can be retrieved later if it is inadvertently deleted
or changed. Once the controller has been programmed, go to
Advanced Menu and select DEFAULT. Press NEXT and STORE
will appear on the display. Press NEXT one more time and wait
several seconds. The display will show COMPLETE to confirm
that you have successfully stored your program. If the controller
has had the operating program changed and you want to return
to the stored program, go to DEFAULT, press NEXT and one
of the arrow buttons. The display will show RETRIEVE. Press
NEXT and the display will show COMPLETE to confirm that the
DEFAULT program has been restored as the operating program.
To clear a stored DEFAULT program you must use the Total
Reset procedure, Section 7.1.
7.0 Troubleshooting
7.1 Total Reset Procedure For The SmartLine® controller
A total reset will clear all programming data in the SmartLine®
controller. All settings will return to factory defaults.
For all SmartLine® models except SL800:
• Turn dial to Advanced Menu.
• While pressing the UP button, use an open paper clip or
ballpoint pen to push in the Reset switch located on the
back of the operating panel. Release the reset button
while continuing to press and hold the UP button.
• Once the display shows CLEARING, release the UP
button.
• Reprogram SmartLine® controller.
For the SL800:
• Unplug the power supply on the side of the SL800.
• Turn dial to Advanced Menu.
• While continually holding down on the UP button,
reapply the power connection to the SL800.
• The display will read “CLEARING” to verify that the
Reset is complete. Re-enter your controller settings.
Troubleshooting 7.0