21
http://support.weathermatic.com
6.14 Clr Pgm
This feature allows the user to clear all programmed values
specific to a selected program. All zone run times and daily start
times will be set to OFF; watering days will default to Days of the
Week (all on); Season % will equal 100% for all months and Run/
Soak will be OFF. Omit times/days are not reset when clearing a
program.
From the CLR PGM menu, press NEXT and the display will show
KEEP. Use PGM button to select program to be cleared. Then,
press either the UP or DOWN button to display CLEAR. With
CLEAR showing in the display, either press NEXT or BACK or
turn the dial to complete the clearing of the selected program.
Likewise, with KEEP showing in the display, either press NEXT or
BACK or turn the dial to keep the selected program.
6.15 Clr All
This feature is similar to CLR PGM except that it clears all user
programmed data for all four programs and returns most
Advanced Menu changes to factory defaults. Turn the dial to
Advanced Menu and use an arrow button to select CLR ALL.
Press the NEXT button and KEEP will show in the display. Press
the UP and DOWN button to select CLEAR. Press NEXT to clear
all programs. The display will show CLEARING to confirm that all
programs have been cleared. Note: This function is not the same
as the Total Master Reset as described under 7.1 in your Owner’s
Manual.
6.16 Wireless
Used to set contractor code or Join function for the optional
SLRC Wireless Handheld Remote Control. Note: This function
only works with the SLW15/SLHUB-RF. It does not work with
the SLW5. The SLRC remote is only operable with the SLW15
Weather Sensor.
6.17 About
Provides information on software version in the SmartLine®
controller.
6.18 Grow In
Grow In allows you to set up a new landscape grow-in watering
program that will automatically expire after a set number of days
that you select. At the end of your selected grow-in period, the
controller will automatically retrieve your long-term watering
program to avoid the necessity of having to return to the
controller.
Step 1: Set up your long-term SMART or BASIC watering
program.
Step 2: Go to Advanced Menu and select DEFAULT. Press
NEXT and STORE will appear on the display. Press NEXT again
and wait several seconds. The display will show COMPLETE to
confirm that you have successfully stored your program.
Step 3: Set up your temporary Grow-In program.
Step 4: Go to Advanced Menu and select GROW IN. Press
NEXT once to view default days for grow in. Use Adjust Value
buttons to select 1 to 99 days for the grow in period. At the end
6.0 Advanced Menu
To Next Page
Loading...
