SNMP
4-65
Trap
Click SNMP and then Trap. This will load the SNMP trap screen shown
below.
Click Save Settings to proceed, or Cancel to change your settings.
Parameter Description
IP Address Traps are sent to this address when errors or specific events
occur on the network.
Community A community string (password) specified for trap
management. Enter a word, something other than public or
private, to prevent unauthorized individuals from reading
information on your system.
Version Sets the trap status to disabled, or enabled with v1 or v2c.
The v2c protocol was proposed in late 1995 and includes
enhancements to v1 that are universally accepted. These
include a get-bulk command to reduce network
management traffic when retrieving a sequence of MIB
variables, and a more elaborate set of error codes for
improved reporting to a Network Management Station.
To Next Page
Loading...
