C
ONFIGURING
THE
B
ARRICADE
4-6
Wireless Settings
Enter your wireless network settings on this page. You must specify a
common radio channel and SSID (Service Set ID) to be used by the
Barricade and all of its wireless clients. Be sure you configure all of its
clients to the same value. For security purposes, you should change the
default SSID immediately.
Parameter Description
Wireless Network Name
(SSID)
The Service Set ID (SSID) is the name of your
wireless network. The SSID must be the same on
the Barricade and all of its wireless clients.
Broadcast Wireless Network
Name
Enable or disable the broadcasting of the SSID. If
you disable broadcast of the SSID, only devices
that have the correct SSID can connect. This
nullifies the wireless network “discovery” feature
of some products such as Windows XP.
(Default: Enable)
Wireless Mode This device supports the following modes; 11g
only, 11b only, 11b/g mixed mode, Super G-
Dynamic Turbo and Super G-Static Turbo.
Wi-Fi Channel Number This device supports the following modes 11g only,
11b only, 11b/g mixed mode, Super G-Dynamic
Turbo and Super G-Static Turbo.
Extend Range Increases the range of the Barricade.
(Default: Disable)
To Next Page
Loading...
